Game Console Construction

This is a high level view of the construction of the console

• The console “top” I wanted as 28“ (71cm) X 11”(28cm)
• I wanted an overhang of 1/2“ (1.25cm) on the left/right/front and flush with the back.
• Therefore, the sides are 10.5” (27.67cm) and the length is 27“ (68.58cm)

Materials

• MDF Board (I seriously hate this stuff and should have spent the extra $$$) - Hardware store
• Plywood bottom - Hardware store
• Plexiglass - Amazon
• Hinges - Hardware store
• Primer - Hardware store
• Internal brackets for support - Hardware store
• Rustoleum Gloss black (Hardware)
• Rubber trim (red) - Amazon
• Rubber padding for the bottom - Amazon

Here's a pic of the pieces. Obviously you can do the math and cut as needed. Remember the bottom will be smaller as it needs to fit into the box.

Covered in another doc