game:hardware
Differences
This shows you the differences between two versions of the page.
| Both sides previous revisionPrevious revisionNext revision | Previous revision | ||
| game:hardware [2026/01/13 14:16] – [List] mlivolsi | game:hardware [2026/01/30 14:33] (current) – [Console] mlivolsi | ||
|---|---|---|---|
| Line 3: | Line 3: | ||
| Here is the list I ordered from GameRoom Solutions and other providers | Here is the list I ordered from GameRoom Solutions and other providers | ||
| - | ==== List ==== | + | ==== Game parts ==== |
| * (1) Track Ball 2 inch Arcade Game Trackball for PC or MAC - USB and PS2 Connectors 1 | * (1) Track Ball 2 inch Arcade Game Trackball for PC or MAC - USB and PS2 Connectors 1 | ||
| Line 11: | Line 11: | ||
| * (8) Blue buttons - Standard 8 buttons | * (8) Blue buttons - Standard 8 buttons | ||
| * (2) Yellow buttons - Game select, etc. | * (2) Yellow buttons - Game select, etc. | ||
| - | * (1) Red button - Game select, etc. | + | * (1) Red button - Game select, etc. <-- Mistake, should have ordered 2 green |
| * (1) HDMI extender | * (1) HDMI extender | ||
| Line 17: | Line 17: | ||
| * (1) Raspberri Pi4 (repurpose an existing one I had) | * (1) Raspberri Pi4 (repurpose an existing one I had) | ||
| + | * (1) Micro USB to HDMI converter | ||
| ==== Console ==== | ==== Console ==== | ||
| Line 23: | Line 24: | ||
| * (1) 4'x 2' 1/2" board (for bottom of the console - also Lowes) | * (1) 4'x 2' 1/2" board (for bottom of the console - also Lowes) | ||
| * (1) 3'x 2' 1/8" Plexiglass (Amazon) | * (1) 3'x 2' 1/8" Plexiglass (Amazon) | ||
| - | * (2) Inside brackets for support | + | * (2) Inside brackets for support |
| * (1) 10' Rubber edge corner trim, ' | * (1) 10' Rubber edge corner trim, ' | ||
| * (1) Neoprene rubber sheet- for base. 1/8" thick 16" | * (1) Neoprene rubber sheet- for base. 1/8" thick 16" | ||
| + | * (1) Vinyl printout - Christmas gift from daughter | ||
| + | |||
| + | ==== Misc. Electronics ==== | ||
| + | |||
| + | I wanted a toggle switch on/off the unit and another to turn on/off button lights. | ||
| + | |||
| + | * Two toggle switches | ||
| + | * 5v power source (at least 3A, to power the Pi) | ||
| + | * 12v power source (to power the lights, which are 12v) | ||
| + | * (1) green LED | ||
| + | * (1) 240 ohm resistor (for LED light, which is 3.3v) | ||
| + | |||
| + | **Temporary electronic requirements** | ||
| + | |||
| + | * USB Keyboard (used for setting up games) | ||
| + | * Network connectivity | ||
| ==== Snacks ==== | ==== Snacks ==== | ||
game/hardware.1768313799.txt.gz · Last modified: by mlivolsi